AnsweredAssumed Answered

Chamfer dimensions wrong on curved surface

Question asked by Alexander Axelsson on Jul 23, 2013
Latest reply on Jul 23, 2013 by Atindra Singh



Everytime that i make a chamfer on the edge of a hole, created on a curved surface/cylinder, the dimensions i am given in the drawings are off.


Example: I create a chamfer using the chamfer feature, 0.5x45º. When i then put the chamfer dimentions in the drawing for the part they show 0.43X44.1º.


Is there anyway to get around this problem aside from overriding the dimensions?


Thank you,