2 Replies Latest reply on Jul 4, 2013 7:43 AM by Andy Lang

split imported surfaces into one surface?

Andy Lang Jul 4, 2013 6:16 AM

Hi all,

Ive been looking for an answer everywhere but cant

I have a tube which is imported surfaces as split surfaces and i wish to simply merge them all into one surface - ie end to end. It knits no problem and is blended but still shows the "split lines".

Any help would be great.

Thanks,

Andy

Re: split imported surfaces into one surface?

JOHN GEORGE Jul 4, 2013 7:12 AM (in response to Andy Lang)

Andy,

When knit surfaces, have you enabled "merge entities"

This discussion may help
Like Show 0 Likes(0)

Actions
- Re: split imported surfaces into one surface?
  
  Andy Lang Jul 4, 2013 7:43 AM (in response to JOHN GEORGE)
  
  Yup, im usually a dab hand at solidworks (my profession) but this never bothered me until now as I need to split other bits out and just want it one body. 98% sure it can be done so its just bothering me now
  
  Thanks
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post