4 Replies Latest reply on Jun 26, 2013 4:31 PM by Matthew Lorono

    Solidworks 2012 - Section View - How to make section line at an angle ?

    Eric Ireland

      Hi everyone,

       

      I have a question about how to create a section view, with the section line at an angle of say 30 degress Clockwise from the vertical.  I had a simple round part with some holes and I wanted to section thru a hole that was positioned at 30 degrees, but the sectioning tool would only let me go vertical or horizontal.  I know there is a way to do this but how ?

       

      Thanks !

       

      Eric