When i make a section view in the assembly and use the measure tool to evaluate a diameter it gives me the radius. Is there a way i can get it to show the diameter automatically still?
The chord length would be equal to the diameter.
only if the section went through the center of the circle.
Craig - no there is not a way to directly get the diameter to show - except when the chord happens to match the diameter.
No, but that would be a good option. I suggest you create an ER & post the SPR number (if or when received) here, so others can add their vote.
I can't believe this still isn't an option in 2019! Drives me nuts.
use the "graphics-only section" option, and you will get the diameter in the measure tool.
Jeremiah Feist You're awesome! Thank you!
Retrieving data ...