AnsweredAssumed Answered

Default Bend Radius

Question asked by Oli Sparrow on Jun 13, 2013
Latest reply on Jun 17, 2013 by Simon Beamish

Hi all,

 

   It seems that every time I create sheet metal parts my default bend radius changes.  It started out as 2mm, jumped up to 1300mm, back to 6mm and so on.  90% of the time I use only R 5mm.

 

   Is there somewhere in options where I can set this.  Alternatively is there something I am doing that is resetting the default while I am modelling?

 

Thanks

Oli

Outcomes