AnsweredAssumed Answered

Need tips on aligning a drawing view!

Question asked by Randall Blair on Jun 5, 2013
Latest reply on Jun 6, 2013 by Peter De Vlieger

So I have this rig. It has some stuts made of 1.5 X 1.5 % .25 steel angle. I need to make a drawing view where the angle is lying horizontal as if the angle piece had been layed on a table so I can dimension it with dimensions that will be useful and easy to measure when that piece is lying on the table.

 

I bet there is a simple way to do this, but I can't seem to figure it out.

Attachments

Outcomes