how do I create a dimension in an assembly that i can modifyu in the design table?
Welcome to SolidWorks forums Mike.
Check the post and example files by Mauricio on the below listed posts:
https://forum.solidworks.com/message/14544#14544
https://forum.solidworks.com/message/130137#130137
https://forum.solidworks.com/message/247837#247837
You might also find this post helpful for your future reference
Welcome to SolidWorks forums Mike.
Check the post and example files by Mauricio on the below listed posts:
https://forum.solidworks.com/message/14544#14544
https://forum.solidworks.com/message/130137#130137
https://forum.solidworks.com/message/247837#247837
You might also find this post helpful for your future reference