AnsweredAssumed Answered

trying to make extruded cut on sheet metal part while its in flattened state....

Question asked by Dave Krum on May 22, 2013
Latest reply on May 22, 2013 by Dave Krum

Hello.  I'm trying to make an extruded cut in a sheet metal part while its in the flattened state.  But when I put the part back in its rolled state, the extruded cut isn't showing.  I was thinking maybe I did something out of order with the rollback bar?  Please see attached .sldprt.  You can see the sketch for the cut in the flattened state but when I unflatten it, the cut for the contour is now gone.  Thanks.

Outcomes