I don't think this looks so swell. Can anyone improve what I've created, but leave the sketches (sketch5 and sketch6) alone? Part is attached.
What exactly are you looking for? The curvature is driven by the sketches, so if they can't change, there is very little that can be done.
Looking for a smooth transition from one sketch to the other. The sketches could be changed slightly, but they match the profile of mating parts. I don't normally do this type of work, so I wasn't sure if the surface I created could be improved, and make the curvature profile look cleaner (to a surfacing rookie).
I tried to open your part but I am on 2012 still. It looks like your sketch is a bunch of segments. You can try to make the sketch a single spline by using the "fit spline" command. there is a checkbox that you may have to uncheck in order to get a segment otherwise it will want to create a closed spline. Can you save as a dumb solid so I can open your part up? Tom
Hadn't thought of using a fit spline. Should keep it close to original sketch. Will give it a shot. iges and parasolid attached.
as tom suggested. see if the attached part file will help you.
That is a lot cleaner than mine. Thanks.
Would something like this be more acceptable?
Would have to see the part file to make the judgement call probably, but does look cleaner than what I started with.
Retrieving data ...