AnsweredAssumed Answered

Termination of sheet metal part

Question asked by Hal Hardin on May 15, 2013
Latest reply on May 15, 2013 by Patrick O'Hern

Trying to generate a part in sheet metal. Is there any way to terminate the end of the part on 2 different surfaces? Selected surface is highlited and I want to include the radius in the selection and SW will not let me. Any sugestions would be great. I have tryed making the part to extend past the surface and then trim it to the two surfaces but I can't get a good flat pattern!

 

sheet metal termination.JPG

Outcomes