11 Replies Latest reply on May 10, 2013 10:42 AM by Paul Marsman

    How to remove all constraints from a part after building it using an Assembly

    Dmitry Ponomarev

      Good afternoon,


      I made a part around an actuator using Part Editing from assembly, so now I have a lot of features of this part that are linked (constrained) to features from the actuator, which is another part.


      Now I would like to unlink them, so that the new part has no dependence on the other part.


      is there a way to do this? Without saving the part as a different format and then importing it