2 Replies Latest reply on May 8, 2013 10:10 AM by robert dattilo

    Sw to Dxf/Draftsite ?

    robert dattilo

      Hello;

       

            I did a saveas dxf from SW. When I open the file through Draftsite, some symbols changed. If I go into the note, & double click it, it asks if

      I want to edit the component. I say ok. Then I'm put in edit mode. I make my change, but then can't seem to accept the edit, with ok, entry, return, escape

      or any entry. Once I enter the edit mode of the note, & make the changes how do I get out of this in Draftsite, & accept the change.

       

      Thanks, in advance for any input;

       

      Rob_D SW 2013 Sp3