10 Replies Latest reply on Aug 27, 2015 11:27 AM by Bhavarth Sharaf

    IExportToDWG Method (IPartDoc)

    Greg Johnson

      When using the IExportToDWG method for Sheet Metal parts is there a way to flip the part over?

       

      I have created code that check the bend lines in a part and if the number of bends down is greater than the number of bends up I want to flip the part over. It looks like the only way I can do this is to change the Sheet Metal Fixed Face to the opposite face. What is the best way to do this programically?