Find the attached picture shows the flow xpress closes when i try to solve the simulation.
BC: Inlet - mass flow rate
Outler - atm pr
I got SW 2013 sp 3.
hi prakash, you may want to remove your serial from the forum. that should be kept private.
has floxpress ever worked on your system?
is the problem happening on every file? (this one looks like a good simple troubleshooting case)
is the file on your desktop? (specifically somewhere that you know you have full control that isn't sync'd or duplicated anywhere)
can you start the solidworks RX tool (solidworks closed) and try the 2 options on the bottom of the first screen to start solidworks with a reset version of the solidworks settings and also bypassing your graphics card.
I tried opening using SW Rx tool, but SW closes without warning.
No, this is a new CPU and trying for the first time in the system. it does not works on any parts . i use C:drive (Win 7 drive) as the location. and i tried D:drive also, but not working.
Which version of win 7? It needs to be pro or ultimate.
I'd guess that your pre recs need to be reinstalled or that you should go with a clean uninstall/reinstall.
If you are still having issues, I'd speak to your reseller or check the swx kb.
S. its win 7 enterprise.
I will try to contact reseller, but what does swx kb means?
Enterprise version should be ok.
Swx kb is the knowledgebase in the solidworks customer portal. I haven't checked but here might be a solution in there.
Retrieving data ...