8 Replies Latest reply on May 2, 2013 4:22 PM by Jeremiah Griffith

    Printing Issues

    Sam Russotto

      Good Afternoon Solidworks Users,

       

      I have a drawing that I would like to send to our plotter.  The problem I am having is that the drawing is pretty much centered on the print preview.  Is there a way you can move the drawing to the bottom left of the paper this way we will only have to trim two sides rather than 4 sides after its being printed?  I went into printer preference and the KIP alignment is set to "Left"  I hope I am clear on my question.  Thank you in advance for your help.