AnsweredAssumed Answered

Need help with Sheetmetal Tutorial, error "The bend allowence of this bend may be too small"

Question asked by David Bernick on May 1, 2013
Latest reply on May 1, 2013 by Bernie Daraz

So im trying to learn some sheetmetal solidworks and Ive gotten stuck on "Bending a Tab" step. Using the Sketched Bend tool Ive followed the directions with the Bend Parameters, but i get the Rebuild error "The bend allowence of this bend may be too small". I thought this misht be due to the previous step "Adding a Tab", and how well defined the rectangle sketch was, but to no avail, see picture below for error. I've attached the file and am going to reboot and see if that helps.

 

Any advice or insight would be helpful.

 

Thank you,

 

David

Sheetmatal tutorial.png

Outcomes