0 Replies Latest reply on Apr 30, 2013 8:51 AM by Brian Mick

    Span Displays - open part on single monitor, not spanned

    Brian Mick

      Hello,

       

      When I am using solidworks across two screens, every time I open a new part it spans both monitors.  I would like to to default to one side or the other (ideally, the side opposite whichever window was active).

       

      Is this possible?

       

      Thanks,

       

      Brian

       

      EDIT: Found a similar unanswered discussion:

      https://forum.solidworks.com/message/293484