How can I get automatically Total Lenght of the same structural member in weldment cut lust or BOM?
In SolidEdge it is really easy.
It is very easy in SolidWorks also. If you do not get an answer until Sunday, I will show you how.
Thank You Alin!
Could You help me also about legs? In the attached drawing you can see that there are 4 legs, but in the table only three, as well as lenght of legs is different - must be 100mm, but no 106mm.
Vladimir, please post the part file also (Steam Boiler Skid.sldprt).
Retrieving data ...