I would like to make a pipe route from an exising 3-D sketch. Is this possible?
Routing does use a 3dsketch but it isn't a plain 3Dsketch. In other words, I don't think you can use your existing sketch and just transform it into a routing sketch by a couple of clicks.
However, if you have a 3Dsketch you can use it as a backbone so to speak and trace it over with a routing sketch. That way you can take advantage of all the positioning and thought behind the original. The only thing to keep in mind is that any future alterations will either have to be to the original sketch or that you'll have to cut the link, where needed, between the original and the routing sketch.
Have a nice one
Thank you Peter.
Retrieving data ...