2 Replies Latest reply on Apr 16, 2013 10:53 AM by Patrick O'Hern

    Attach rev in lower right to current rev

    robert dattilo

      Hello;

       

              Wondering what's the best way to attach the lower right revision space so that it would change, when a new revision is added. Sometimes this gets missed doing it manually. To clarify you start with "A" revision, then go to "B", in the block itself. But the letter in the bottom right corner, stays "A", unless it's manually changed. These are

      Company Title block sheets, not the Solidworks sheets.

       

      Thanks, in advance for any input;

       

      Rob_D SW 2013 sp2.