Tell me whether it is possible to perform a mirror route?
I'm trying to create a mirror, but the mirror SW makes me kompanenty without route!
If you create a without mirror, SW reverses the route, which is the same.
It should be possible depending on which version of Solidworks you use.
Don't forget to select the "create opposite hand version" while doing the Mirror Components.
It also depends what you expect of the mirror. If just mirror of components then it will be no problem.
However, as far as I know, you can't do a mirror of the route sketch. In other words you can't create a mirror and then edit the mirror version. Unless you start to use workarounds, tricks etc.
It would be nice if you could make a mirror sketch in SW.
When mirroring the route and editing the sketch, it is easier to re-draw)
i dont believe that the ability to create opposite version of routing components is possible. at least i couldnt do it in 2012.
correct mirroring a 3d sketch is not possible...
i never had much luck with the mirroring of routes. What i would do is mirror what would work and then edit the route, select add to route and drop the fittings that would not come in properly
Yes. this is so. I have tried many options. solutions not found: (
I never have experienced any problem with mirroring. The only nuisance is because there's no mirrored 3dsketch it's a bit cumbersome to say the least if it has to alter.
I once had a, lucky small, project that on the very last minute had to be mirrored only for them to come to the conclusion that it wasn't to be a perfect mirror because this that and the other had to be modified.
With the release of the project the same way I did, but then I still had to do the right route for later use.
I do not see the solution to my problem, which is bad
Retrieving data ...