Hi all
Iv run a simulation and the dispacement sensor gave this reading - below first image - with a deformation scale of 1. From the picture, is that showing in general displacement would happen or is that saying that that is going to happen? Because from the stress result it seems fine as the readings are well below the materials yeild point. i added that screen shot aswell just so u can see it.
Thanks
Displacement is the change of location for a point. It seems that the maximum displacement will be roughly 0.2mm. Is this what you are asking?
yes thats what i meant, just needing a bit of assistance reading the results. i can see the results but when the colour comes into i panic a little bit as it goes red and red=bad. but i realise now that its just a representation of where the worst part is not that its totally wrong.
thanks for the help
i don't think your displacement sensor information got posted. (unless you just mean the displacement plot)
as richard mentioned, the results are the results. those are the stresses and displacements the assembly will see under the load that you applied.
Displacement is the change of location for a point. It seems that the maximum displacement will be roughly 0.2mm. Is this what you are asking?