I need to print a 1 & half frame E size sheet 36x72 how do I increase the plot area in the SLDDRT file.
I altered the sheet I can't set the plot area too the new sheet size.
Is there a custom setting all I see are the standard sizes.
Go to File > Page setup and change the paper size there (check attached picture if that helps)
You might also find this post helpful for your future reference.
There where two things I needed too know.
The first was to stretch the sheet from the right side to the right for a longer sheet.
Second set the sheet size using custom sheet size in the sheet properties.
That gave me what I was looking for.
Deepka Gupta thanks for the link to your post on using the forum, that will be helpful in the future.
I don't agree about Winrar as far as I am concerned forget Winzip, if all you do is zip up Solidworks then Winrar is all you need.
Retrieving data ...