We just switched to 2013 SP2 and it seems to take a very long time to save files. Our files are saved to a network drive. Any ideas on why it would take so long to file?
what version were you on before the upgrade? If you were on 2012 then SW is probably converting the files when you save them. That will take longer on the first save.
I thought that would slow it down but this is dirt dog slow. I mean real slow. We were on 2012 SP4
Thanks for your suggestions, I found out that is was a network setting and once we changed that, things greatly improved.
What did you changed at your network settings? We have the same problem!
I have attached a pic. I went into the control panel, network sharing and changed the property value of the speed and duplex to what is shown in the attached pic.
You just switched the Speed from "Auto" to "Full Duplex"? That's all?
Thats all I did and I took care of my problem. Have you tried it?
After I switched from Auto to Full Dupelx it becomes slower!
Maybe I should change the port setting of the Network-Switch too, but thats a lot of work and I'm not sure if this wil help me.
The transfer rate of our netwrok is ok. 80-100MB/s if I copy a 1 GB File.
But when we open a assembly group with 40-50 different parts or other smaller assembly groups we have waiting time from 10-25 Min. if the part is open!
Retrieving data ...