AnsweredAssumed Answered

SolidWorks 2013 - Problem with flat pattern of a half circle w/ flanges!

Question asked by Lance Tschetter on Mar 4, 2013
Latest reply on Mar 9, 2013 by Bernie Daraz

We just updated to 2013 and SolidWorks is not giving me an accurate flat pattern of a part that I am drawing. I am trying to draw a pipe clampe so it is a half circle with a flange on each side to clamp 2 - 8" pipes together. It will not allow me to flatten the part accuratly and gives me a huge flat pattern. Anybody else experiencing these problems?

Outcomes