AnsweredAssumed Answered

A little help - Routing internal, and setting default c-point

Question asked by james demarco on Feb 27, 2013
Latest reply on Jul 16, 2013 by james demarco

Hello all - two part question in routing.

 

1. If I uncheck the save route externally in my options (to keep it internal to the assembly) when I attempt to start a new route it asks me for a template, but the pop up is balnk??

 

2. When using "start at point" the default end length adjusment is alway 10mm - where on earth do I go to change that setting to zero?

 

min length.JPG

Outcomes