2 Replies Latest reply on Feb 21, 2013 10:32 AM by Matthew Lorono

    Drawing Templetes

    Steven Clark

      My sheet is always set to first angle ( type of projectiosn) is there a way to make it automatic goto third angle?

        • Re: Drawing Templetes
          Mark Thomas

          Steven,

           

          Create new drawing from your template > RMB on sheet > select Properties > select button as shown.

           

          Then save the sheet as your drawing template.

           

          Mark

          • Re: Drawing Templetes
            Matthew Lorono

            Also, next time you install solidworks (not upgrade), be mindful of the messages that come up the first time you start SolidWorks afterwards.  One of the questions asks if which standard.  If you are using ANSI, the default is already 3rd angle, so be sure to pick ANSI when asked.  If you are using ISO and still want to use 3rd angle, then you'll have to update your templates after the fact since 1st angle is the default for ISO.