1 Reply Latest reply on Mar 12, 2013 2:10 PM by Lenny Bucholz

    pierce quirk

    Ray Fletcher

      I am trying to pierce the end point of a spline to the edge of a circular surface. When I select the end point of the spline, and the edge that I want the spline to pierce, the end point appears to pierce it just fine. But when I close the sketch, the end point jumps all the way across the model to the opposite side and pierces there instead. It actually extends the spline, dragging it across the model.

       

      Has anyone else experienced such a wierd quirk like this?

       

      Ray

        • Re: pierce quirk
          Lenny Bucholz

          Yes, I have had to make a construction line by using the intersection tool in sketch entities and pierce to both the edge and the construction.

           

          because cicles don't have a start or end this happen every now and then, just depends on the model.