Need help trying to flatten this sheetmetal part. It is from Pro-E format.
Thanks in advance.
Sorry, I did not mention I'm still using SW 2012 version. Were you able to flatten out? If so, what did you do?
Put a SW2012 version in my original post for you.
I had to use Import Diagnostics to eliminate 2 stray faces, then use planar surface to replace one of them, knitted to solid and then used Convert to Sheetmetal feature.
I imported the .prt file as a solid body, then selected the face shown in the pic as my fixed face, then clicked "collect all bends."
Ticked ok and all worked fine. DXF attached also, hope it helps.
Here ya go. Had to do a little import model repair and then was able to use "convert to sheetmetal.
Retrieving data ...