Hi. This is my 1st post so please forgive me. I am needing to dimension from the edge of an arc to the outside of the sketch. When i try it always grabs the center of the arc. How can i dimension to the edge?
Welcome to the forum. If you've already placed the dimension, you can click on it to highlight it, go to the PropertyManager, click on the Leaders tab, and go to the Arc Condition section at the bottom. "Center" will be chosen by default, but you can choose "Min" or "Max".
DJ,
If you hold down the Shift key while dimensioning it will grab the tangent of the arc/circle.
Frank