Dear Deepak Sir,
As instruction & guide by you i am learning animation tutorial by the help of you .
I am trying cylinder animation as per your provided pdf file but i am unable to create it
kindly have a look & help me
You need to correct the extrude feature. Check the video.
Ok thanks i will do today myself
it's working fine for me.
Pal an u conform what's working fine for you
The procedure to create the cylinder animation works fine for me as per the pdf file which you have attached above.
Have u create this animation
yes, i created this animation as per the procedure mentioned by Deepak.
Shiv can you post your animation as created by you for my refrence
Please find the attached SW files. I am using SW 2012.
ohhhh No but i have Solid-works 2010 have you any idea that futur version file open in low version
as per my knowledge its not possible. However, i will try to create it in 2007.
Attached files are in SW 2007. You can check these files.
It's working fine & i have checked it..
Have you any other animation file by which i can learn something because i am new in solidworks also new on forum
I have some another pdf file for animation which provided by deepak sir
if you required then tell me i upload file ...............
I am unable to do inplace mate can u help me
can you share the files please?
have a look
Its working fine at my end. are you facing issues in motion study?
Animation working fine at my end also
but when i attempt to create same then i unable to do nplace mate
see attached file
This mate will come when you start a new part in the assembly mode itself. While in assembly press Insert > Part > New and then pick a plane/surface and you'll get this mate.
Pal & Deepak sir
I have done
Please mark this question as answered.
Retrieving data ...