Hello all,
I'm not a super user of tubing and routings, but I do get by. My issue is with my tubes shifting away from the c point. I usually am able to do an edit route and then it snaps back to place. However, I have one file (with too many tubes to re do) where this trick won't work.
Has anyone experienced this before and have any ideas on how to makes these re connect? I'll attach a screen shot of this, in case my explaination is unclear.
Thank you for the help!
Richard,
Thanks for the quick response.
The entire assembly is a copy. I then copied the tubing files and re-linked to the new assembly.
Ok, make sure you have a new copy (model assy - copy.sldasm) that you are using so that the original does not get messed up. Did the re-link work? By that I mean did you
1. copy the route assembly
2. save copy externally
3. Edit route sketch
4. delete original relations
5. create new relations to new model assembly
I think my terminology got worked around a little. I meant is the route-assy a copy?
It may help to get a screenshot of the tree or post a pack-and-go.zip
Check the routing sketch to make sure the coincident and concentric relations are still in place. Also, make sure this assembly is not a copy of another assembly.