0 Replies Latest reply on Jan 18, 2013 6:36 AM by jose junior

    Termination signals for general machining

    jose junior

      He had already mentioned this forum ni old; however like to put on the agenda again.

      When we run a breakdown in certain sides of the piece, there is a symbol of machining (eg triangles = 3).

      We always have to indicate on drawing the overall finish of the piece (eg triangle = 1) as well, solidworks not understand the sign already indicated, we will indicate when the overall finish (See attached example). Believe it would help a lot, if that feature was equal to Autocad

       

      http://i51.fastpic.ru/big/2012/1228/0f/33aef6c650aa65bbfd7a84ee435dff0f.gif

       

      There is the possibility to create a custom property to enter the general finishing just automatically choosing the properties?

       

      Regards,