I am creating a Layout sketch for a top down assembly. The sketch is on the front plane (I think. That is where I created it.) I was happily dimensioning things, when the dimensions suddenly went a little odd. Attached is a screen shot showing the problem. Any advice would be appreciated.
Wow, the aspect ratio is a little screwed up on this view. Still shows the problem. Check out the 20.879 and 16.867 dimensions.
Thanks.
Mike,
To see your screen dump in the proper proportions, it is best to open it in another window.
I don't have a clue as to why the two dimensions don't show a break in the line.
Jerry S.
