3 Replies Latest reply on Jan 15, 2013 1:55 PM by Jeremy Feist

    Importing ProE (Creo Parametrics 1.0) parts into SolidWorks...

    Steve Sell

      I'm using SoldWorks 2013 SP0.0 and a customer has provided the ProE (CREO Parametrics 1.0) files to us. I can see the files when I change to the ProE/Creo filetype (both parts & assemblies) but when I load the assembly, it comes up empty. The customer has told me that these are the same files they are using and are a valid file they can still open/use when sent back to them. Unfortunately due to confidentiality agreements, I'm unable to post the files for others to test/review. I'm not sure if there's a config/setting I need to change to allow these to load fully. Any help on this topic would be greatly appreciated.