AnsweredAssumed Answered

Cell drop-down list enabled - Not Working In SW2013???

Question asked by Cristian Fustos on Jan 6, 2013
Latest reply on Sep 5, 2013 by Marcello Jacobs

Hello all,

I just installed SW2013 on my laptop. I have parts with design tables created in SW 2012. The design tables have drop down lists for different values. When I open the design table in SW2013, the drop-down disappears. I reconnect the drop downs, close design table and reopen, and same problem. No error message or warning. The only message I get is to a part that doesn't have drop down list...  See attached. Is there a setting to enable/disable the drop-down list or SW2013 "fixed" a non-existing issue?

Outcomes