We do a lot of weldments. It would greatly increase accuracy and speed if I could have the circular split line balloon without the border. Does anyone know if this is possible?
You can click on the balloon to highlight it and bring up the PropertyManager. In the section that says something like "Border Type" choose "None" from the drop-down. I'm at home now and don't have SW here, so I'm not sure about the exact wording and can't post a screenshot.
There is no option to do that with the current version. You may want to talk to your VAR or long on to customer portal account for raising an enhancement request
Apparently I gave bad advice. I don't use split line balloons. Is the"None" border style not available for them?
I'm confused. It has "None" listed in your screenshot right above "Circular".
Yes it is there but not with a split option as required by the Shane.
OK. Thanks for clearing that up.
I was going to suggest the stacked text option but you can only use around 8 characters so that will not work for what you are showing. So you will need to fake it with a separate leader and two pieces of text then make a block out of it or group it together. As Deepak suggested create an enhancement request if you need to do this a lot.
You can use a note but the leader is off and the quantity is not parametric.
Retrieving data ...