AnsweredAssumed Answered

Deleting parts from an assembly

Question asked by Kirk Oden on Dec 21, 2012

Since I changed over to 2013 when I am in an assembly and I click on a part of a subassembly it is deleting the part I clicked on not the entire subassembly. In this case it is deleting the outer race of a bearing. When I go into the bearing assembly it loads with the race but then once it regenerates it is removed. Is there an easy way to get it to show the race? This bearing is used in a TON of parts and I would hate to redo the assemblies. I have even tried to replace the bearing assembly with one that has the race in it and it does the same thing.

Outcomes