AnsweredAssumed Answered

without saving the assembly, changes on part are gone !!!

Question asked by Christian Chu on Dec 21, 2012
Latest reply on Dec 21, 2012 by Christian Chu

There might be some changes in SW2012 which I am not aware of or there might be an option I accidentally turned on/off

I work on a part and make some changes on it. Then I save and close the part

Since the assembly file is big (about 1000 components) and I make no change on it so I close the assembly without save it ( It'd take a while if I save the assembly) - then if I close the assembly wihout saving it  and open the part,  then all the changes on the part is gone - I don't think this works same as previous releases

Am I correct or missing something here?

Thx

Outcomes