AnsweredAssumed Answered

How Do I select an edge curve / sketch from a part in my assm. to cut a feature in another part i'm editing ?

Question asked by Tony Smith on Dec 25, 2012
Latest reply on Dec 25, 2012 by Glenn Schroeder

Hello

I searched the board and could not find this one.

(But i'm sure its here somewhere) 

I have a block in my assembly and and a part inside the middle of it.

(It is going to be wire edm'ed out of it on the manufacturing side)

I'm trying to edit the block and pick the sketch or outside edge curve of the part to be Cut out via Feature Extrude cut.

It wont let me pick it ?

How do I get the sketch transfered to the main block so I can pick it"

 

EDIT: I was able to edit part / Sketch /  convert entities / intersection.

Then delete all the newly formed sketch entiites I didnt need.

and pick only the outside one and run feature extrude cut !

Got it, messy but its done.

 

Thank You

Tony S.

Outcomes