Hi there,

I am relatively new to solidworks, and I am hoping some one might be able to help me with a slight problem I am having with projected curves. I am using 2 sketches on 2 differnt planes and the two lines in the sketches are coincident but when I project the curve the projected curve is short by a tiny bit not allowing me to sweep along, I have re-drawn it a few time to make sure the sizes are correct but i cant figure out why the curve is short.

Hopefully some one can help me and point me in the right direction, thanks.

Thank you for the reply and the modified part, it allowed me to work out where I had went wrong and what I needed to do.

Here is the part that i was looking to make.

Thanks again.