The error comes with the message attached in the file.
Thanks Dony for your concern. I finally came t know that the size of my solidworks data folder was not proper. So I have Copied the same folder from my friend's pc and now its running fine.
Is that Assy is created or opened in some other PC??
the Every toolbox path is must in same location.Then only the toolbox components will open properly.
Seems like you've a used an assembly made on a different machine with different toolbox. And once you opened the assembly, toolbox on your machine couldn't find some of the hardware configuration and tried to create one.
Hi, thanks for your concern. actually I have uninstalled sw 2012 sp4 from my machine and Installed 2013sp0 on the same machine. so, earlier it was running perfectly but after this operation it is giving me the message.
Run the toolbox updating utility and make sure you update your old toolbox data file.
But it is already in the latest version
OK check that configuration of that particular hardware in the toolbox? Does it exists? Also check if the standard has been updated or exists in the toolbox.
Also do you've back up of your toolbox data.
If your Toolbox parts are saved to a specific location, is this box checked since you updated to SW2013?
Thanks Glenn, I cheked it.It is already cheked.
Please repair your installation and try open again.
Just repair SolidWorks, the other's program you can uncheck like eDrawing and etc.
Retrieving data ...