I just upgraded to 2013 SP1.0

I have a .step file that I need to recognize as a sheet metal part.  I run feature works recognize features and the only thing it does is recognizes a couple of cuts (just holes).  It does not recognize any flanges or bends.  I still see the Imported item in the feature manager tree.  Basically it does not do anything.  This was not the case with 2012.  I can use convert to sheet metal but does not allow me to edit any flange profiles, heights, etc.  Also a change from 2012 I believe.

I unfortunately had to unistall 2012 due to disk space on my SSD so I am unable to test with the older version.

Has anyone else run into this?