1 Reply Latest reply on Dec 13, 2012 3:44 AM by Dave Laban

Remote Load

Lakhvinder Singh Dec 13, 2012 1:33 AM

All,

Consider there is an assembly, and we need to simulate the operating conditions under an load. Is it possible to make a line or dot (by sketch), away from the assembly and apply the load through/indirection of the dot or line? This is in context to simulate an external load on an assembly where the load is far/away from the assembly. Thanks in advance.

Regards,

Re: Remote Load

Dave Laban Dec 13, 2012 3:44 AM (in response to Lakhvinder Singh)

It is possible, and without the need for an additional sketch / line / point. The "Remote Load/Mass" tool in the External Loads folder fulfils this functionality.
Like Show 0 Likes(0)

Actions