On the attached part, is is possible to twist the top bend to make the center of the 3mm hole to be Coincident to/ over right side edge some how?
Thanks in advance!
If that's what you are looking for I would do it like this. Dimensions on the bend line give you more exact control over the shape and a usable flat pattern. Or did you want to wrap the end around so the axis of the hole is perpendicular to the big hole axis?
It looks like this:
You can do a Flex, setting your planes inside the bend flats so they won't get skewed. Then adjust your twist angle until you're happy. No way I know to absolutely constrain it, unless you make your part that way (leave out the bend portion, to a curve, and loft face to face following curve).
That would be much easier if they are making the part, and yes give a usable flat pattern as the Flex will take it away (will have to suppress it to view)
Thank you both!
It wasnt more difficult than that? .... I guess it wass a little late for me yesterday :|
I think I would like to use Eriks solution, because that one cand be flat also.
Retrieving data ...