1 Reply Latest reply on Nov 14, 2012 12:21 PM by Jeremy Feist

    Draft View

    Jason Lackey

      OK, I havent seen anything too recent in regards to this, but I only went about three pages into my search.  In regards to the topic, I know that it is said that you recieve the pop up in regards to views being draft views if you hit save too early, but I get that pop up even if I leave a drawing sitting for 10 minutes, and I mean a small three page assembly drawing with a few views, nothing crazy.  What is causing this and how can I make it stop?!!

       

      TIA,

       

      Jason Lackey

      11-9-2012 8-54-36 AM.png

        • Re: Draft View
          Jeremy Feist

          it would seem that you views are complex enough that it is taking your machine longer than 10 minutes to render the drawing views. look for an hourglass symbol over the view(s) icon(s) in the FM. when those are gone, SW is done computing the view(s).