4 Replies Latest reply on Nov 12, 2012 10:27 PM by Duncan Gillis

Free modeling in SolidWorks

Maksim Shniak Nov 6, 2012 1:40 PM

Good afternoon. I have long wanted to ask, is planned in the future to add SolidWorks Simulation module free, similar to T-splines or Imagine & Shape (CATIA). Thank you in advance for your reply.

Re: Free modeling in SolidWorks

Jerry Steiger Nov 6, 2012 3:01 PM (in response to Maksim Shniak)

Maksim,

I don't think you are going to get any useful answers to that question. The folks who might know the answer are unlikely to tell us about it until they are ready to announce it to the world.

Jerry S.
Like Show 0 Likes(0)

Actions
- Re: Free modeling in SolidWorks
  
  Maksim Shniak Nov 6, 2012 4:45 PM (in response to Jerry Steiger)
  
  Thanks for the answer, yes, I've thought about it, it's a big industry and big market, so it is not just about to say. But I have heard that in the spring will SolidWorks V6 and it will be for the conceptual design. I think there should be such a module as T-splines.
  I sure hope so ... I think that I am not alone hope
  
  Like Show 0 Likes(0)
  
  Actions
  - Re: Free modeling in SolidWorks
    
    Shon Owl Nov 11, 2012 5:18 AM (in response to Maksim Shniak)
    
    May be :-). Without T-spline also can do hard things
    
    Like Show 0 Likes(0)
    
    Actions
Re: Free modeling in SolidWorks

Duncan Gillis Nov 12, 2012 10:27 PM (in response to Maksim Shniak)

check out Modo 601 with the SubD-Nurbs Addin
http://www.luxology.com/power_sub-d_nurbs/
Has a couple of Modo to Solidworks examples.

Hope this helps.
Like Show 0 Likes(0)

Actions

Go to original post