I went to the Toolbox, ANSI INCH, Spring washers, create part, configure for 1" type A washer.
Anyone see anything wrong with this washer?
What is your concern here? The OD seems to be OK. The ID should be slightly more than 1".
Are we looking at the same picture? The O.D. of the washer attached to the post is .869. This is supposed to be a lockwasher for a 1" bolt. The O.D. is smaller than the bolt diameter. What are you looking at? I tried create part, when the configuration panel opens, I specify 1.0", click on the green checkmark. Filename says it is LW 1.0". With an O.D. of .869, that is clearly not correct. Help me understand.
Please check that value again as that should be Radius and not Diameter else post the file here to check.
To check it quick double click on the feature and see what you get for OD/ID.
I created a sketch on the surface, convert entities, dimensioned the arc, RMB display as Diameter. The radius is half that value. After further investigation, when I decided to just modify the part to make it right, when I "configure dimension", the configurator appears and shows a "Preview configuration". The dimensions of the "Preview configuration are correct, but that configuration does not show up in the configuration pane. The only configurations shown, are default and 0.5. When closing the configurator, the actual model reverts to the 0.5 configuration.
Can you attach the generated file.
Retrieving data ...