were working with rather large weldment cutlists sometimes up to 500 parts, im looking for an easier way to handle the bom for our assembly drawings. i can get my cutlist names to pull on the bom but i have to input them manually in the cutlist properties. i need to find a way for the name to pull automaticly using a link command. ex sw-mass@@@11pa1@randompart.sldprt or if its a different command im not sure.
running solidworks 2012 sp1
I have seen an SPR on this issue in the knowledge base. It seems that it is a limitation at this point to link to the cut list item name.
See SPR 335774.