4 Replies Latest reply on Oct 8, 2012 12:24 PM by Lenny Bucholz

when relations are turned off they still come back after selecting geometry!!!!!!!!!

Lenny Bucholz Oct 6, 2012 11:31 AM

We have just gotten SW2012 and when I turn off the relations all is good until I have to move a bunch of geometry, SW hanges and then all the relations to the sketch come back on.

SW2011 didn't do this, can I turn this off somewhere????? Help pain in the ......................

thanx

Re: when relations are turned off they still come back after selecting geometry!!!!!!!!!

Lenny Bucholz Oct 6, 2012 11:39 AM (in response to Lenny Bucholz)

here's a pic, same logo copied so they have all the same relations, see the one selected pops up all the icons...!!!
Like Show 0 Likes(0)

Actions
Re: when relations are turned off they still come back after selecting geometry!!!!!!!!!

Jerry Steiger Oct 7, 2012 2:27 PM (in response to Lenny Bucholz)

Lenny,

I still haven't loaded 2012, so it is a bit stupid of me to say anything, but I'm hoping to clarify what is happening. When you say that "relations are turned off", I take it to mean that you have turned off Sketch Relations under View?

Jerry S.
Like Show 0 Likes(0)

Actions
- Re: when relations are turned off they still come back after selecting geometry!!!!!!!!!
  
  Lenny Bucholz Oct 8, 2012 12:21 PM (in response to Jerry Steiger)
  
  Jerry,
  
  meaning veiwing the icons is turned off from the pull down of veiw. but if you then select any geom the icons com back as the pic shows.
  
  the other BN's are in the same sketch and node selected...no icons.
  
  Like Show 0 Likes(0)
  
  Actions
- Re: when relations are turned off they still come back after selecting geometry!!!!!!!!!
  
  Lenny Bucholz Oct 8, 2012 12:24 PM (in response to Jerry Steiger)
  
  found it, SP0!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! UUUUUUUUUUUUUUGGGGGGGGGGGGGGGGGGGGGGGGG!
  
  OK in SP5, YEA!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post